The driver on the Toshiba ( with the problem) is showing as the "new" driver r8101 but the driver on the ASUS is showing Ģ. I put 255.255.255.0 in the Net Mask Column.but it has changed to 24 for some reason! don`t know if I am doing the right thing.ġ. MisterW has pointed at the driver, and from the linky he provided, it seems it`s been a bit of a problem with I have done a MANUAL insert of the IP address Both installs were from a new download and done within 24 hours of each other. I don`t think the install of mint is corrupted, as it was run from the same Live USB as for the main ASUS laptop. ( which had no problems running mint or wired connection! ) and never had this problem UNTIL I got this Toshiba Satellite Pro 12 inch, to replace a 10 inch laptop. I have changed the Main board, on which the LAN socket is, for two others,Īny suggestions to solve the above problem would be appreciated. On the IPV4 section Using the same IP address Using the same Interface name for the router I have copied the same information from the Asus to the Toshiba on the "Editing Wired Connections" page. Icon shows "broken" connection and Ethernet Network "disconnected" I have disabled WIFI but kept Networking enabled I have been through the BIOS settings to make sure that LAN is enabled ( has always been, as far as I know ! ). Toshiba 12inch Satellite Pro will not connect via the (same) ethernet cable but will connect via WIFI. (and new ethernet cables ) Works really good.On the Asus. Router is upstairs, and connection to it, is via Power Plug adapters. connects to the internet via Ethernet and also via WIFI. both running Linux Mint 21.2 Vera - Mate editionĪsus Laptop. In this article, we have covered the two methods of connecting to WiFi.Two Laptop. Connecting Linux Mint to a WiFi network is quite an easy process. to connect laptops, tablets, PCs, and smartphones to the internet. WiFi is the most widely used computer network used globally at home, offices, coffee shops, etc. Once you enter the above command, the connection will be established and you can confirm it by using the IP command. Step 4: Execute the following line of code to apply the netplan configuration change after executing the command given below $ sudo netplan -debug apply Password: "Password of your wireless network" Now, simply enter your information, append the following lines, and then save the document. The first three lines will be present once you open it in a text editor It will ask you to enter the network name and password for the network you want to connect to. Open this file in nano or another text editor at this point. Step 3: The “1-network-manager-all.yaml” file will subsequently be returned. The network interfaces, where you can place your wireless network configuration, are configured by Netplan using the YAML description files. Step 2: This step involves configuring the network file by running the netplan utility command. ![]() You can use the ls command to obtain a list of accessible networks. To make it so, enter the directory’s location, “/sys/class/net.” It will trace the available networks. ![]() Step 1: In this method, the first thing you should do is trace your wireless network by going to the directory that contains network information. ![]() To allow Linux Mint to connect to WiFi, you must run several commands. From The Command Line InterfaceĮvery Linux system includes a command line of one sort or another. Now that we’ve covered one of the two methods for connecting to the network using the GUI in Linux Mint, let’s talk about the other one. A “Connection Established” prompt will show up once your device is connected to the network successfully. Step 2: Next, choose the network you want to use to connect your device, then enter the password to complete the connection. Step 1: Click on the connection symbol, it will show up the list of all the accessible WiFi networks, as shown in the image below.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |